Specify custom packages from fifteen basic sizes as follows:
1. Generate model number:
(A) Case Size, case sizes are determined by first 3 digits of all model numbers
|
MODEL NO. |
SIZE |
| 701 |
1 11/32"(34.04) x 1 11/32"(34.04) |
| 702 |
1 1/4"(31.8) x 2 1/2"(63.5) |
| 704 |
2"(50.8) x 3"(76.2) |
| 705 |
1 1/2"(38.1) x 3 1/4"(82.6) |
| 707 |
3"(76.2) x 4 1/2"(114.3) |
| 708 |
2"(50.8) x 5"(127.0) |
| 712 |
2"(50.8) x 2"(50.8) |
| 714 |
1 3/4"(44.5) x 1 3/4"(44.5) |
| 715 |
1 1/2"(31.1) x 1 1/2"(31.1) |
| 716 |
3"(76.2) x 3"(76.2) |
| 717 |
2 1/2"(63.5) x 2 1/2"(63.5) |
| 718 |
4"(101.6) x 4"(101.6) |
| 720 |
2"(50.8) x 6"(152.4) |
| 721 |
2"(50.8) x 4"(101.6) |
| 726 |
3"(76.2) x 5"(127.0) |
|
Dimensions are in inches (millimeters) |
(B) Height, overall height includes two 1/16" thick covers. Minimum 3/4", maximum 3" Examples: 075=3/4 height, 250= 2 1/2" high, 175= 1 3/4" high
(C) Number of connectors, examples 0=none, 1, 2, 3 etc.
(D) Type of female RF connectors (4 types available) examples:0= none, 1= BNC, 2= TNC, 3= Type N, 4= SMA (3mm)
(E) Number of Feedthrus, examples 0=none, 1,2, 3 etc.
(F) Type of Feedthrus, examples 0=none 1= P-011 plain Teflon type 1.8 pf with 8-32 thread for mounting, 2= P-000 filter type, 5,000 pf with 8-32 thread for mounting.
(G) Special features, SP used to designate cutouts, slots, drilled holes, tapped holes, special finish, groove pins, etc.
2. Locate connectors and Feedthrus, the centerline of any connector or freedthru must be located a minimum of 9/16" from any outside corner and a minimum of 3/8" up form the bottom or down from the top of the case, including covers. Connectors may not be closer than 3/4" center-to-center, feedthrus 5/16". Connectors will be centered in height on the case unless otherwise specified.
3. Complete your design
| A | B | C | D | E | F | G |
| 712 | 225 | 2 | 4 | 2 | 2 | SP |
Model 712-225-24-22-2P is a 2" x 2" x 2 1/4" High case with two (2) Type SMA connectors, two (2) Filter type feedthrus, and special features.